Mini Drone,EACHINE E010 Mini UFO Quadcopter Drone 2.4G 4CH 6 Axis Headless Mode Remote Control Nano Quadcopter RTF Mode 2 (Red)


  • 【HEADLESS MODE】The EACHINE E010 drone will change its flight direction with the change of the direction of remote control.
  • 【ONE-KEY RETURN】 With built-in positioning system, the drone can auto locate the remote control, just press the one key return button, the drone will fly back to the remote control's location.
  • 【360°ROLL-OVER】 The simple flying of WSAD is to boring, and the new 3D rolling special effects surprise all the people.
  • 【LED LIGHTS】The outside of four-axis stabilizer blade is installed with four colorful LED lights which can indicate the direction when flying in night sky.
  • 【STEPS TO MATCH CODE 】1. Turn on the quadcopter then turn on the controller; 2. Push the throttle(left lever) to the top , and then pull it down; 3. When you hear a "Beep", which means the connection was set up successfully, and then you can start to fly your drone.
Description:
Item name: Eachine E010 Mini Quadcopter
Quadcopter Size: 9.5X9.5X5CM
Box Size: 14X8.6X11CM
Gyro: 6-axis
Frequency: 2.4G
Channel:4CH
Battery: 3.7V (150MAH) (included)
Flight time: about 5 minutes
Charging time: 30 ~ 50 minutes
Flying distance: 30 meters

Function: up / down / left turn / right turn / forward / back / left side fly / right side fly / speed file/ 360° flip/ a key return / headless mode / memory function

Package included: 1x Quadcopter
1x Transmitters
1x USB charging cable
1x manual
4x propeller

Commen Problem and The Solution
1. Quadcopter lost connection to controller: Pull two function lever to bottom left for 3 seconds, then pull two function lever to bottom right for 3 second. Then try to mach code again(Follow Bullet points 4 );

2. Quadcopter can't lift up: Check the propeller to make sure it was installed correctly(diagonal propellers must be the same direction );

3. Motor not spin: Check the motor to see if anything stuck the motor(hair, string, etc)

Didn't find what you were looking for?